Command Line Reference Guide

496 | Dell Networking OS Resilient Ring Protocol (FRRP)
www.dell.com | support.dell.com
Parameters
Defaults
Default as shown
Command Modes
CONFIGURATION (conf-frrp)
Command
History
Usage
Information
The hello interval is the interval at which ring frames are generated from the primary interface of the
master node. The dead interval is the time that elapses before a timeout occurs.
hello-interval
milliseconds
Enter the keyword hello-interval followed by the time, in milliseconds,
to set the hello interval of the control packets. The milliseconds must be
enter in increments of 50 milliseconds, for example 50, 100, 150 and so on.
If an invalid value is enter, an error message is generated.
Range: 50 to 2000ms
Default: 500 ms
dead-interval
milliseconds
Enter the keyword dead-interval followed by the time, in milliseconds,
to set the dead interval of the control packets.
Range: 50 to 6000ms
Default: 1500ms
Note: The configured dead interval should be at least three times the
hello interval
Version 8.2.1.0 Introduced for the C-Series
Version 7.4.1.0 Introduced