Command Line Reference Guide

396 | Border Gateway Protocol IPv4 (BGPv4)
www.dell.com | support.dell.com
Parameters
Defaults
No default values or behavior
Command Modes
ROUTER BGP
Command
History
MBGP Commands
Multiprotocol BGP (MBGP) is an enhanced BGP that enables multicast routing policy throughout the
Internet and connecting multicast topologies between BGP and autonomous systems (AS). Dell
Networking OS MBGP is implemented as per IETF RFC 1858.
Dell Networking OS version 7.8.1.0 and later support MBGP for IPv6 on e
t
and c platforms.
Dell Networking OS version 7.8.1.0 and later supports MBGP for IPv4 Multicast only on the s
platform.
Dell Networking OS version 8.2.1.0 and later support MBGP on the E-Series ExaScale e
x
platform.
The MBGP commands are:
• address family ipv4 multicast (MBGP)
• aggregate-address
• bgp dampening
• bgp soft-reconfig-backup
• clear ip bgp dampening
• clear ip bgp flap-statistics
• clear ip bgp ipv4 multicast soft
• debug ip bgp dampening
• debug ip bgp dampening
• debug ip bgp dampening
• debug ip bgp peer-group updates
• debug ip bgp ipv4 unicast soft-reconfiguration
• debug ip bgp updates
• distance bgp
• neighbor activate
keepalive
Enter a number for the time interval, in seconds, between keepalive messages sent
to the neighbor routers.
Range: 1 to 65535
Default: 60 seconds
holdtime
Enter a number for the time interval, in seconds, between the last keepalive
message and declaring the router dead.
Range: 3 to 65535
Default: 180 seconds
Version 7.8.1.0 Introduced on S-Series
Version 7.7.1.0 Introduced on C-Series
Version 7.6.1.0 Introduced on E-Series