Manualshelf

Command Line Reference Guide

ManualsBrandsDell ManualsserversDell C7004/C150 Aggregation Core chassis Switch
1501150215031504150515061507150815091510
16 |
www.dell.com | support.dell.com
Command Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant
Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Usage
Information
The VLT domain ID must be the same between the two VLT devices. If the domain ID is not the same,
a syslog message is generated and VLT does not launch.
Related
Commands
vlt-peer-lag port-channel
c
Associate the port channel to the corresponding port channel in the VLT peer for the VLT connection
to an attached device.
Syntax
vlt-peer-lag port-channel id-number
Parameters
Defaults
Not configured.
Command Modes
INTERFACE PORT-CHANNEL
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant
Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 8.4.6.0 Introduced on the C-Series.
show vlt brief Uses the show vlt brief command to display the delay-restore
value.
id-number
Enter the respective vlt port-channel number of the peer device.
Version 8.4.6.0 Introduced on the C-Series.