Command Line Reference Guide

| 5
The following is a list of the Dell Networking OS version history for this command.
peer-link port-channel
c
Configure the specified port channel as the chassis interconnect trunk between VLT peers in the
domain.
Syntax
peer-link port-channel port-channel-number {peer-down-vlan vlan id}
Parameters
Defaults
Not Configured.
Command Modes
VLT DOMAIN
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant
Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Usage
Information
To configure the VLAN from where the VLT peer forwards packets received over the VLTi from an
adjacent VLT peer that is down, use the peer-down-vlan parameter.
peer-routing
c
Enable L3 VLT peer-routing.
Syntax
peer-routing
To disable L3 VLT peer-routing, use the no peer-routing command.
Defaults
Disabled.
Command Modes
VLT DOMAIN (conf-vlt-domain)
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant
Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 8.4.6.0 Introduced on the C-Series.
port-channel-nu
mber
Enter the port-channel number that acts as the interconnect trunk.
peer-down-vlan
vlan id
Enter the keyword peer-down-vlan then a VLAN ID to configure the
VLAN that the VLT peer link uses when the VLT peer is down.
Version 8.4.6.0 Introduced on the C-Series.
Version 8.4.6.0 Introduced on the C-Series.