Command Line Reference Guide

| 3
Command Modes
EXEC
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant
Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Example
Related
Commands
delay-restore
c
Configure the delay in bringing up VLT ports after reload or peer-link restoration between the VLT
peer switches.
Syntax
delay-restore
Parameters
Defaults
Not Configured.
Command Modes
VLT DOMAIN
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant
Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Usage
Information
To delay the system from bringing up the VLT port for a brief period to allow IGMP Snooping and
Layer 3 routing protocols to converge, use the delay-restore parameter. Use this feature:
• after a VLT device is reloaded.
• if the Peer VLT device was up at the time the VLTi link failed to the time when it was restored.
Related
Commands
Version 8.4.6.0 Introduced on the C-Series.
VLT ARP Statistics
----------------
ARP Tunnel Pkts sent:0
ARP Tunnel Pkts Rcvd:0
ARP-sync Pkts Sent:0
ARP-sync Pkts Rcvd:0
ARP Reg Request sent:19
ARP Reg Request rcvd:10
show vlt statistics Displays statistics on VLT operations.
delay-restore
Enter the amount of time, in seconds, to delay bringing up the VLT ports
after the VLTi device is reloaded or after the peer-link is restored between
VLT peer switches. The range from 1 to 1200. The default is 90 seconds.
Version 8.4.6.0 Introduced on the C-Series.
show vlt statistics Displays statistics on VLT operations.