Command Line Reference Guide

VLAN Stacking | 1475
Related
Commands
show interface dei-mark
c s
Display the dei mark configuration.
Syntax
show interface dei-mark [interface slot/port | linecard number port-set number]
Parameters
Command Mode
EXEC Privilege
Command
History
Example
FTOS#show interface dei-mark
Default CFI/DEI Marking: 0
Interface Drop precedence CFI/DEI
------------------------------------------------
Gi 0/1 Green 0
Gi 0/1 Yellow 1
Gi 8/9 Yellow 0
Gi 8/40 Yellow 0
Related
Commands
vlan-stack access
c e s
Specify a Layer 2 port or port channel as an access port to the Stackable VLAN network.
Syntax
vlan-stack access
To remove access port designation, enter no vlan-stack access.
dei honor
interface slot/port Enter the interface type followed by the line card slot and port
number. Enter the following keywords and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet
followed by the slot/port information.
• For a Port Channel interface, enter the keyword port-channel followed
by a number:
C-Series Range: 1-128
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to
512 for ExaScale.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
followed by the slot/port information.
• For a VLAN interface, enter the keyword vlan followed by the VLAN
ID. The VLAN ID range is from 1 to 4094/
linecard number
port-set number
Enter linecard followed by the line card slot number, then enter port-set
followed by the port-pipe number.
Version 8.4.6.0
Added support for the keyword
fortyGigE.
Version 8.3.1.0 Introduced on C-Series and S-Series.
dei mark