Command Line Reference Guide

Storm Control | 1431
storm-control multicast (Interface)
c s
Configure the percentage of multicast traffic allowed on an C-Series or S-Series interface (ingress
only) network only.
Syntax
storm-control multicast packets_per_second in
To disable multicast storm control on the interface, use the no storm-control multicast
packets_per_second in command.
Parameters
Defaults
No default behavior or values
Command Modes
INTERFACE (conf-if-interface-slot/port)
Command
History
storm-control unknown-unicast (Configuration)
c e s
Configure the percentage of unknown-unicast traffic allowed in or out of the network.
Syntax
storm-control unknown-unicast [percentage decimal_value [in | out]] | [wred-profile
name]] [packets_per_second in]
To disable storm control for unknown-unicast traffic, use the no storm-control unknown-unicast
[percentage decimal_value [in | out] | [wred-profile name]] [packets_per_second in]
command.
Parameters
Defaults
No default behavior or values
Command Modes
CONFIGURATION
Command
History
packets_per_second
in
C-Series and S-Series Only: Enter the packets per second of broadcast traffic
allowed into the network.
Range: 0 to 33554431
Version 7.6.1.0 Introduced on C-Series and S-Series
percentage
decimal_value [in |
out]
E-Series Only: Enter the percentage of broadcast traffic allowed in or out of the
network. Optionally, you can designate a decimal value percentage, for
example, 55.5%.
Percentage: 0 to 100
0 % blocks all related traffic
100% allows all traffic into the interface
Decimal Range: 0.1 to 0.9
wred-profile name E-Series Only: (Optionally) Enter the keyword wred-profile followed by
the profile name to designate a wred-profile.
packets_per_second
in
C-Series and S-Series Only: Enter the packets per second of broadcast traffic
allowed into the network.
Range: 0 to 33554431
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series