Command Line Reference Guide

1388 | SNMP and Syslog
www.dell.com | support.dell.com
logging
c e s
Configure an IP address or host name of a Syslog server where logging messages will be sent. Multiple
logging servers of both IPv4 and/or IPv6 can be configured.
Syntax
logging {ipv4-address | ipv6-address | hostname} [vrf vrf-name]
To disable logging, enter no logging.
Parameters
Defaults
Disabled
Command Modes
CONFIGURATION
Command
History
Related
Commands
logging buffered
c e s
Enable logging and specify which messages are logged to an internal buffer. By default, all messages
are logged to the internal buffer.
Syntax
logging buffered [level] [size]
To return to the default values, enter default logging buffered. To disable logging stored to an
internal buffer, enter no logging buffered.
Parameters
Defaults
level = 7; size = 40960 bytes
Command Modes
CONFIGURATION
ipv4-address |
ipv6-address
Enter an IPv4 address (A.B.C.D) or IPv6 address (X:X:X:X::X) address.
vrf vrf-name
(OPTIONAL) Enter the keyword vrf followed by the name of the VRF. Range: 1 to 63.
hostname
Enter the name of a host already configured and recognized by the switch.
Version 8.4.6.0 Added support for VRF.
Version 8.4.1.0 Added support for IPv6.
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
E-Series legacy command
logging on Enables the logging asynchronously to logging buffer, console, Syslog server, and
terminal lines.
logging trap Enables logging to the Syslog server based on severity.
level
(OPTIONAL) Indicate a value from 0 to 7 or enter one of the following
equivalent words: emergencies, alerts, critical, errors, warnings, notifications,
informational, or debugging.
Default: 7 or debugging.
size
(OPTIONAL) Indicate the size, in bytes, of the logging buffer. The number of
messages buffered depends on the size of each message.
Range: 40960 to 524288.
Default: 40960 bytes.