Command Line Reference Guide

SNMP and Syslog | 1385
Usage
Information
The oid-tree variable is a full sub-tree starting from 1.3.6 and can not specify the name of a sub-tree or
a MIB. The following example configures a view named rview that allows access to all objects under
1.3.6.1:
Example
Figure 54-10. snmp-server view Command Example
Related
Commands
snmp trap link-status
c e s
Enable the interface to send SNMP link traps, which indicate whether the interface is up or down.
Syntax
snmp trap link-status
To disable sending link trap messages, enter no snmp trap link-status.
Defaults
Enabled.
Command Modes
INTERFACE
Command
History
Usage
Information
If the interface is expected to flap during normal usage, you could disable this command.
Syslog Commands
The following commands allow you to configure logging functions on all Dell Networking switches:
• clear logging
• default logging buffered
• default logging console
• default logging monitor
• default logging trap
• logging
• logging buffered
• logging console
• logging facility
• logging history
• logging history size
• logging monitor
• logging on
FTOS# conf
FTOS#(conf) snmp-server view rview 1.3.6.1 included
show running-config snmp Display the SNMP running configuration
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
E-Series legacy command