Command Line Reference Guide

1382 | SNMP and Syslog
www.dell.com | support.dell.com
Command
History
Usage
Information
For this snmp-server trap-source command to be enabled, you must configure an IP address on the
interface and enable the interface configured as an SNMP trap source.
Related
Commands
snmp-server user
c e s
Configure a new user to an SNMP group.
Syntax
snmp-server user name {group_name remote ip-address vrf vrf-name udp-port
port-number} [1 | 2c | 3] [encrypted] [auth {md5 | sha} auth-password] [priv des56 priv
password] [access-list-name | ipv6 access-list-name | access-list-name ipv6
access-list-name]
To remove a user from the SNMP group, use the no snmp-server user name {group_name
remote ip-address vrf vrf-name udp-port port-number} [1 | 2c | 3 ] [encrypted] [auth {md5 |
sha} auth-password] [priv des56 priv password] [access-list-name | ipv6 access-list-name |
access-list-name ipv6 access-list-name] command.
Parameters
Version 8.4.6.0
Added support for the keyword
fortyGigE.
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
E-Series legacy command
snmp-server community Set the community string.
name
Enter the name of the user (not to exceed 20 characters), on the host, that
connects to the agent.
group_name
Enter a text string (up to 20 characters long) as the name of the group.
Defaults: The following groups are created for mapping to read/write
community/security-names.
• v1v2creadu — maps to a community with
ro permissions
•
1v2cwriteu — maps to a community rw permissions
remote ip-address
Enter the keyword remote followed by the IP address that identifies the copy of
the SNMP on the remote device.
vrf vrf-name
Enter the keyword vrf followed by the name of the VRF. Range: 1 to 63.
udp-port
port-number
Enter the keyword udp-port followed by the UDP (User Datagram Protocol)
port number on the remote device.
Range: 0 to 65535.
Default: 162
1 | 2c | 3
(OPTIONAL) Enter the security model version number (1, 2c, or 3).
•
1 is the least secure version
•
3 is the most secure of the security modes.
•
2c allows transmission of informs and counter 64, which allows for integers
twice the width of what is normally allowed.
Default: 1
encrypted (OPTIONAL) Enter the keyword encrypted to specify the password appear in
encrypted format (a series of digits, masking the true characters of the string).
auth (OPTIONAL) Enter the keyword auth to specify authentication of a packet
without encryption.