Command Line Reference Guide

Quality of Service (QoS) | 1237
wred-profile
e
Create a WRED profile and name that profile.
Syntax
wred-profile wred-profile-name
To remove an existing WRED profile, use the no wred-profile command.
Parameters
Defaults
The five pre-defined WRED profiles. When a new profile is configured, the minimum and maximum
threshold defaults to predefined wred_ge_g values
Command Modes
CONFIGURATION
Command
History
Usage
Information
Use the default pre-defined profiles or configure your own profile. You can not delete the pre-defined
profiles or their default values. This command enables the WRED configuration mode—(conf-wred).
Related
Commands
Queue-Level Debugging
Queue-Level Debugging is an E-Series-only feature, as indicated by the e character that appears
below each command heading.
The following queuing statistics are available on both the EtherScale and TeraScale versions of
E-Series systems.
• clear queue statistics egress
• clear queue statistics ingress
• show queue statistics egress
• show queue statistics ingress
wred-profile-name
Enter your WRED profile name in character format (16 character maximum). Or
use one of the pre-defined WRED profile names. You can configure up to 26
WRED profiles plus the 5 pre-defined profiles, for a total of 31 WRED profiles.
Pre-defined Profiles:
wred_drop, wred-ge_y, wred_ge_g, wred_teng_y, wred_teng_g
pre-Version 6.1.1.1 Introduced on E-Series
threshold Specify the minimum and maximum threshold values of the WRED profile