Command Line Reference Guide

1150 | Power over Ethernet (PoE) and Power over Ethernet Plus (PoE+)
www.dell.com | support.dell.com
Related
Commands
show power supply
c s
Display the power supply status.
Syntax
show power supply
Command Modes
EXEC
EXEC Privilege
Command
History
C-Series
Example
Figure 43-1. show power supply (C-Series) Command Example
Table 43-3 describes the ten possible power supply status conditions for the C-Series.
User Priority Displays the power you configured for the port (default is low). See power
inline priority.
LLDP Support Displays the power requested is via LLDP-MED extended power-via-mdi TLV
or IEEE 802.3at power-via-mdi TLV.
Table 43-2. show power inline Command Output Field Description
power inline Enable power to be supplied to a device connected to a port.
power inline priority Set the PoE priority of the selected port
Version 8.4.5.0 Added Line Mode to command output on the C-Series.
Version 7.7.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Table 43-3. Power Supply Status Conditions for the C-Series
AC Fail The power supply is unplugged.
Active The PSU is supplying power to the chassis.
Fail The PSU has failed.
Absent The PSU is not installed in the chassis.
Overload The PSU has turned off due to overload.
Over Temperature Shutdown The PSU has turned off due to an high temperature condition.
Over Temperature Warning The temperature of the PSU is greater than the recommended maximum
operating temperature.
Over Current Warning The PSU load is almost or exceeded its recommended maximum load.
FTOS#show power supply
Power Model Line
Supply Number Type Status Mode
--------------------------------------------------------------------------------
PEM0 CC-C-1600W-AC AC Powered Off NA
PEM1 CC-C-1600W-AC AC Fail NA
PEM2 CC-C-1600W-AC AC Active High(1600W)
PEM3 CC-C-1600W-AC AC Power supply fan fail NA
PEM4 CC-C-1600W-AC AC Active Low (1200W)
PEM5 CC-C-1600W-AC AC Overload NA
PEM6 CC-C-1600W-AC AC Over Temperature Shutdown NA
PEM7 CC-C-1600W-AC AC AC Fail NA