Command Line Reference Guide

Open Shortest Path First (OSPFv2 and OSPFv3) | 1027
Defaults
Not configured.
Command Modes
ROUTER OSPF
Command
History
Usage
Information
The distribute-list out command applies to routes being redistributed by autonomous system boundary
routers (ASBRs) into OSPF. It can be applied to external type 2 and external type 1 routes, but not to
intra-area and inter-area routes.
enable inverse mask
c e
Dell Networking OS, by default, permits the user to input OSPF network command with a net-mask.
This command provides a choice between inverse-mask or net-mask (the default).
Syntax
enable inverse mask
To return to the default net-mask, enter no enable inverse mask.
Defaults
net-mask
Command Modes
CONFIGURATION
Command
History
fast-convergence
c e s
This command sets the minimum LSA origination and arrival times to zero (0), allowing more rapid
route computation so that convergence takes less time.
Syntax
fast-convergence {number}
To cancel fast-convergence, enter no fast convergence.
Parameters
Defaults
None.
Command Modes
ROUTER OSPF
Command
History
Version 7.8.1.0 Introduced support for Multi-Process OSPF.
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.1.1.1 Introduced on E-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.1.1.1 Introduced on E-Series
number
Enter the convergence level desired. The higher this parameter is set, the
faster OSPF converge takes place.
Range: 1-4
Version 7.8.1.0 Introduced on all platforms.