Reference Guide

Power over Ethernet and Power over Ethernet Plus | 807
Figure 36-13 is a screenshot showing some of the steps, above, and the resulting running-config.
2 Create an input policy-map containing all three class-maps,
and assign each class-map a different service queue.
policy-map-input
service-queue
CONFIGURATION
POLICY-MAP-IN
3 Create two input QoS policies, one each for PC data and
voice signaling. Assign a different bandwidth weight to each
policy.
qos-policy-out
bandwidth-weight
CONFIGURATION
QOS-POLICY-IN
4 Create an output policy map containing both QoS policies,
and assign them to different service queues.
policy-map-out
service-queue
CONFIGURATION
POLICY-MAP-OUT
5 Assign a strict priority to unicast traffic in queue 3.
strict-priority
CONFIGURATION
6 Apply the input policy map you created in Step 2 to the
interface connected to the phone, and apply the output
policy map you created in Step 4 to the interface connected
your desired next-hop router.
service-policy
INTERFACE
Step Task Command Command Mode