Reference Guide

Version Description
9.3.0.0 Introduced on the Z9000 platform.
Defaults The default trigger-threshold value is 60.
Usage Information The trigger-threshold of bandwidth usage, which determines when the calculation
of link-bundle utilization is performed, is set at 60 percent of the link-bundle
bandwidth. When the total traffic use (mean) is below the trigger-threshold
percentage, unevenness in link-bundle traffic distribution is not reported. If traffic
unevenness is detected in three consecutive measurements, an alarm is issued. The
time interval between measurements is defined by the rate interval for HiGig link
polling (default 15 seconds).
show hardware hg-stats
Display the traffic statistics from internal ports in a HiGig link bundle/port channel on a line-card or
switch fabric module (SFM) NPU.
C9000 Series
Syntax
show hardware {sfm npu-id | linecard slot} hg-stats {port hg-
port—number | unit npu-id port hg-port—number}
Parameters
sfm npu-id Specify a switch SFM (spine) NPU by entering the keyword
sfm and SFM NPU ID. Valid SFM NPU IDs are 0 to 1.
linecard slot Specify a line-card (leaf) NPU by entering the keyword
linecard and line-card slot. Valid slot numbers are 0 to 11.
hg-stats {port hg-
port-number |
unit npu-id port
hg-port-number}
Enter the keyword hg-stats to display HiGig port statistics.
For an SFM NPU HiGig link bundle, specify only a HiGig port
number. Valid SFM hg-port-number values are 1 to 33.
For a line-card NPU HiGig link bundle, specify an NPU ID
and a HiGig port number. Line-card NPUs range is 0. Line-
card HiGig port numbers range from 27 to 32.
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
Version Description
9.9(0.0) Introduced on the C9010.
9.3.0.0 Added support for the hg-stats option on the Z9000
platform.
9.2.1.0 Introduced on the Z9500.
Interfaces
971