Reference Guide

shutdown — disables/enables the port channel.
group
Group two LAGs in a supergroup (“fate-sharing group” or “failover group”).
C9000 Series
Syntax
group group_number port-channel number port-channel number
To remove an existing LAG supergroup, use the no group group_number
command.
Parameters
group_number Enter an integer from 1 to 32 that uniquely identifies this
LAG fate-sharing group.
port-channel
number
Enter the keywords port-channel then an existing LAG
number. Enter this keyword/variable combination twice,
identifying the two paired LAGs.
Defaults none
Command Modes PORT-CHANNEL FAILOVER-GROUP (conf-po-failover-grp)
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the C-Series, E-Series, and S-Series.
Related
Commands
port-channel failover-group — accesses PORT-CHANNEL FAILOVER-GROUP
mode to configure a LAG failover group.
show interfaces port-channel — displays information on configured Port Channel
groups.
956
Interfaces