Reference Guide

1000MegHalfDplx : False
1000Base-T Status
Master/Slave Fault : No
Master/Slave : Slave
Local RX OK : False
Remote RX OK : False
Link Partner 1G FD : False
Link Partner 1G HD : False
Idle Err Cnt : 0
PHY Extended Control
MDI Crossover_mode : Enabled
Example
Related
Commands
show interfaces — displays information on a specific physical interface or virtual
interface.
show interfaces status
To display status information on a specific interface only, display a summary of interface information or
specify a line card slot and interface.
C9000 Series
Syntax
show interfaces [interface | linecard slot-number] status
Parameters
interface (OPTIONAL) Enter one of the following keywords and slot/
port or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port (ports or port-
range) information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port (ports or port-range)
information.
• For a Loopback interface, enter the keyword loopback
then the slot/port information. The range is from 0 to
16383.
• For a Port-Channel interface, enter the keyword port-
channel
then the number. The range is from 0 to 128.
• For a port extender Gigabit Ethernet interface, enter the
keyword peGigE then the pe-id / stack-unit / port-id
information. The pe-id range is from 0 to 255; the stack-
unit unit-number range is from 0 to 7; and the port-id
range is from 1 to 48.
NOTE: The peGigE interface option is only visible when
the feature extended bridge is enabled.
linecard slot-
number
(OPTIONAL) Enter the keyword linecard then the slot
number. The slot ID is from 0 to 11.
926
Interfaces