Reference Guide

linecard portmode
Split a single 40G port into four 10G ports on the switch.
C9000 Series
Syntax
linecard slot-id port number portmode quad
Parameters
linecard slot-id Enter the slot ID of a line card to reset. The range of slot IDs
is from 0 to 11.
number Enter the port number of the 40G port to be split. The port
range is from 0 to 20. A 40G port number is a multiple of 4;
for example, 0, 4, 8, 12, ... 120, 124, 128).
Defaults Disabled.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
Usage Information
Enabling quad mode on a port removes the interface configurations (if any) on the
port after a save and reload. Be sure that the port is removed from other L2 and L3
feature configurations.
You must save and reload the system for the 40G to 4x10G port change to take
effect.
This command cannot be used if LR4 optics are inserted in the 40G port.
monitor interface
Monitor counters on a single interface or all interfaces on a line card. The screen is refreshed every five
seconds and the CLI prompt disappears.
C9000 Series
Syntax
monitor interface [interface] [linecard slot-id]
To disable monitoring and return to the CLI prompt, press the q key.
Parameters
interface (OPTIONAL) Enter the following keywords and slot/port or
number information:
886
Interfaces