Reference Guide

Mode of IPv4 Address Assignment : NONE
DHCP Client-ID :a068003f92bd
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed 1000 Mbit, Mode full duplex
Auto-mdix enabled, ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 02:44:11
Queueing strategy: fifo
Input Statistics:
5150004 packets, 4996095648 bytes
164432 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte
pkts
0 over 255-byte pkts, 4985572 over 511-byte pkts, 0 over
1023-byte pkts
0 Multicasts, 0 Broadcasts, 5150004 Unicasts
0 runts, 0 giants, 0 throttles
0 CRC, 0 overrun, 0 discarded
Output Statistics:
11165065 packets, 714564160 bytes, 0 underruns
11165065 64-byte pkts, 0 over 64-byte pkts, 0 over 127-
byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-
byte pkts
309 Multicasts, 0 Broadcasts, 11164756 Unicasts
0 throttles, 0 discarded, 0 collisions, 0 wreddrops
Rate info (interval 299 seconds):
Input 140.00 Mbits/sec, 18070 packets/sec, 14.30% of
line-rate
Output 20.00 Mbits/sec, 39175 packets/sec, 2.60% of
line-rate
Time since last interface status change: 02:37:06
Related
Commands
show interfaces — displays the interface configuration.
interface loopback
Configure a Loopback interface.
C9000 Series
Syntax
interface loopback number
To remove a loopback interface, use the no interface loopback number
command.
Parameters
number Enter a number as the interface number. The range is from
0 to 16383.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Interfaces
875