Reference Guide

Defaults Not configured.
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series ExaScale.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Documentation modified — added Management to
distinguish from duplex (10/100 Interfaces).
Usage Information This command applies to the Management interface on the route processor
modules (RPMs) and port extender (PE) ports.
Related
Commands
• interface ManagementEthernet — configures the Management port on the
system (either the Primary or Standby RPM).
• management route — configures a static route that points to the Management
interface or a forwarding router.
• speed (Management interface) — sets the speed on the Management interface.
flowcontrol
Enable and disable link-level flow control (802.3x pause frames) on an interface and (optionally)
configure buffer thresholds for pause and offset frame transmission.
C9000 Series
Syntax
flowcontrol rx {off | on} tx {off | on} [pause-threshold
{1-12480}] [resume-offset {1-12480}]
Parameters
rx on Enter the keywords rx on to process the received flow
control frames on this port.
rx off Enter the keywords rx off to ignore the received flow
control frames on this port.
tx on Enter the keywords tx on to send control frames from the
port to the connected device when a higher rate of traffic is
received.
870
Interfaces