Reference Guide

Defaults none
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.0 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
Related
Commands
show hardware — displays the data plane or management plane input and output
statistics for a specified hardware component.
remote-exec
Debug and troubleshoot switch hardware using remote commands.
WARNING: Use the remote-exec command only with the guidance of an engineer from Dell
Networking Technical Support.
C9000 Series
Syntax
remote-exec {cp | rp | linecard slot-id} hw-command
Parameters
cp Enter the keyword cp to troubleshoot Control Processor
CPU operation.
rp Enter the keyword rp to troubleshoot Route Processor CPU
operation.
linecard slot-id Enter the linecard slot-id to troubleshoot line-card
CPU operation. The range of line-card slot IDs is from 0 to
11. Each line-card CPU processes packets on the
corresponding line card on your switch.
hw-command Enter the debug command that Dell Networking Technical
Support gives you.
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Debugging and Diagnostics
721