Reference Guide

Ranges for the CAM profiles are from 1 to 10, except for the ipv6acl profile which
is from 0 to 10. The ipv6acl allocation must be a factor of 2 (2, 4, 6, 8, 10).
If you enabled BMP 3.0, to perform a reload on the chassis to upgrade any
configuration changes that have changed the NVRAM content, use the reload
conditional nvram-cfg-change command.
cam-audit linecard
Enable audit of the IPv4 forwarding table on all line cards.
C9000 Series
Syntax
cam-audit linecard all ipv4-fib interval time-in-minutes
Parameters
all Enter the keyword all to enable CAM audit on all line
cards.
ipv4-fib Enter the keyword ipv4-fib to designate the CAM audit on
the IPv4 forwarding entries.
interval time-in-
minutes
Enter the keyword interval followed by the frequency in
minutes of the CAM audit. Range: 5 to 1440 minutes (24
hours). Default: 60 minutes.
Defaults Disabled
Command Modes CONFIGURATION
Command History
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
7.4.1.0 Introduced on the E-Series.
Usage Information Enables periodic audits of the software and hardware copies of the IPv4 forwarding
table.
72
Control and Monitoring