Reference Guide

ipv4pbr number
Enter ipv4pbr and the FP block number for IPv4 PBR ACL.
The FP block number range is 0 to 6.
iscsioptacl
number
Enter iscsioptacl and the FP block number for ISCSI
optimization ACL. The FP block number range is 0 to 6.
openflow number
Enter openflow and the FP block number for OpenFlow
ACL. The FP block number range is 0 to 6.
vrfv4acl number
Enter vrfv4acl and the FP block number for VRF ACL. The
FP block number range is 0 to 6.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
9.2(0.0) Added support for the fcoe parameter on the S4810 and
S4820T.
9.1.(0.0) Added support for OpenFlow on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Added the keywords fcoeacl and iscsioptacl on the
S4810.
8.3.11.1 Introduced on the Z9000.
8.3.1.0 Added the keywords ecfmacl, vman-qos, and vman-
dual-qos.
8.2.1.0 Introduced on the S-Series.
7.8.1.0 Introduced on the C-Series.
Usage Information
For the new settings to take effect, save the new CAM settings to the startup-
config (write-mem or copy run start) then reload the system.
The total amount of space allowed is 16 FP Blocks. System flow requires four
blocks and these blocks cannot be reallocated. The total number of blocks must be
equal to 12. The
ipv4acl profile range is from 0 to 8.
When configuring space for IPv6 ACLs, the total number of Blocks must equal 12.
Control and Monitoring
71