Reference Guide

Version Description
9.6(0.0) Removed from the S-series. Replaced by the dcb-map
commands.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
To associate a priority group with an ETS output policy with scheduling and
bandwidth configuration, create a DCB output policy. You can apply a DCB output
policy on multiple egress ports. When you apply an ETS output policy on an
interface, ETS-configured scheduling and bandwidth allocation take precedence
over any configured settings in QoS output policies.
The ETS configuration associated with 802.1 priority traffic in a DCB output policy
is used in DCBX negotiation with ETS peers.
Related
Commands
dcb-map — to configure PFC and ETS on Ethernet ports that support converged
Ethernet traffic.
dcb-policy output
Apply the output policy with the ETS configuration to an egress interface.
C9000 Series
Syntax
dcb-policy output policy-name
To delete the output policy, use the no dcb-policy output command.
Parameters
policy-name Enter the output policy name.
Defaults none
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.6(0.0) Removed from the S-series. Replaced by the dcb-map
commands.
9.0.2.0 Introduced on the S6000.
Data Center Bridging (DCB)
653