Reference Guide

dcb-policy input stack-unit stack-ports all
Apply the specified DCB input policy on all ports of the switch stack or a single stacked switch.
C9000 Series
Syntax
dcb-policy input stack-unit {all | stack-unit-id} stack-ports
all dcb-input-policy-name
To remove all DCB input policies applied to the stacked ports and rest the PFC to
its default settings, use the no dcb-policy input stack-unit all command.
To remove only the DCB input policies applied to the specified switch, use the no
dcb-policy input stack-unit command.
Parameters
stack-unit-id Enter the stack unit identification.
dcb-input-policy-
name
Enter the policy name for the DCB input policy.
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.6(0.0) Removed from the S-series. Replaced by the dcb-map
commands.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
pfc no-drop queues
Configure the port queues that still function as no-drop queues for lossless traffic.
C9000 Series
Syntax
pfc no-drop queues queue-range
To remove the no-drop port queues, use the no pfc no-drop queues
command.
642
Data Center Bridging (DCB)