Reference Guide

show ip protocol-queue-mapping
Display the CPU queue mapping for IPv4 protocols.
C9000 Series
Syntax
show ip protocol-queue-mapping queue-id
Defaults Not configured.
Command Modes EXEC Privilege
Usage Information
The show output displays information on CPU traffic flows for IPv4 protocols,
including the ingress queue at which the traffic is queued and the CPU to which
protocol traffic is sent with the applied rate limits (configured or default) in kilobits
per second (kbps). The egress port queues on CPUs are abbreviated as: RP (Route
Processor), CP (Control Processor), and LC (line card).
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.8.0 Introduced on the S4810.
Example
Dell#show ip protocol-queue-mapping
Protocol Src-Port Dst-Port TcpFlag Queue EgPort
Rate (kbps)
-------- -------- -------- ------- ----- ------
-----------
TCP (BGP) any/179 179/any _ Q13
RP 2500
UDP (DHCP) 67/68 68/67 _ Q6
CP 1200
UDP (DHCP-R) 67 67 _ Q6
CP 1200
TCP (FTP) any 21 _ Q3
CP 400
ICMP any any _ Q5
CP 300
IGMP any any _ Q12
RP 300
TCP (MSDP) any/639 639/any _ Q12
RP 100
UDP (NTP) any 123 _ Q3
CP 200
OSPF any any _ Q13
RP 2500
630
Control Plane Policing (CoPP)