Reference Guide

STATION MOVE/TTL1/IP OPTION/
L3 MTU FAIL/SOURCE MISS 0 0 0
Related Command clear control-traffic protocol
show control-traffic queue
Display per-queue counters of rate-limited control-plane traffic.
C9000 Series
Syntax
show contol—traffic queue {all | queue-id queue-number}
counters
Parameters
all Enter the keyword all to display counters for rate-limited
traffic on all CPU queues, including Route Processor,
Control Processor, and line-card CPUs.
queue-id queue-
number
Enter the queue number to display counters for rate-limited
traffic on a specified CPU queue. For the C9000 Series, the
range of queue-number values is from 0 to 20. The twenty-
one control–plane queues are divided into groups of seven
queues for the Route Processor, Control Processor, and
line-card CPUs as follows:
C9000 Series
• Queues 0 to 6 process packets destined to the Control
Processor CPU .
• Queues 7 to 13 process packets destined to the Route
Processor CPU.
• Queues 14 to 20 process packets destined to the line
card CPU.
Defaults None
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
Control Plane Policing (CoPP)
627