Reference Guide

Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
Usage Information
The display reflects the settings implemented with the cam-acl-egress-pe
command.
This command only displays the details of CAM ACL egress profiles configured
globally on the PE. It does not display CAM ACL egress profiles for each PE.
Example
Dell# show cam-acl-egress-pe
-- Port extender Egress Cam ACL --
Current Settings(in block sizes)
1 block = 256 entries
L2Acl : 1
Ipv4Acl : 1
Ipv6Acl : 2
test cam-usage
Verify the CAM space that is available for IPv4 and IPv6 CAM profiles, and particularly to verify if enough
CAM space is available for the IPv6 ACLs you use in a policy map.
C9000 Series
Syntax
test cam-usage service-policy input policy-map-name linecard {number portset
{port-pipe-number} | all}
Parameters
input policy-map-
name
Enter the name of the policy map to verify. Maximum is 32 characters.
linecard number
portset port-pipe-
number
Enter a line card and port-pipe number to check CAM usage on specified
ports. The range of valid port-pipe numbers is 0 to 3. Enter linecard all to
verify the CAM space available for all ports on the switch.
Defaults None
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant
Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
616
Content Addressable Memory (CAM)