Reference Guide

Parameters
ebgp Enter the keyword ebgp to enable multipath support for
External BGP routes.
ibgp Enter the keyword ibgp to enable multipath support for
Internal BGP routes
number Enter a number as the maximum number of parallel paths.
The range is 1 to 16. The default is 1.
Defaults 1
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Command History
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.2.1.0 Introduced on the E-Series ExaScale.
7.4.1.0 Introduced
Usage Information If you enable this command, use the clear ip bgp command to recompute the
best path.
neighbor activate
This command allows the specified neighbor/peer group to be enabled for the current AFI/SAFI.
C9000 Series
Syntax
neighbor {ipv6-address | peer-group-name} activate
To disable, use the no neighbor {ipv6-address | peer-group-name}
activate command.
Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
peer-group-name Identify a peer group by name.
activate Enter the keyword activate to enable the identified
neighbor or peer group in the new AFI/SAFI.
Defaults Disabled.
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Command History
Version Description
9.9(0.0) Introduced on the C9010.
562
Border Gateway Protocol