Reference Guide

debug ip bgp keepalives
Allows you to view information about BGP keepalive messages.
C9000 Series
Syntax
debug ip bgp [ipv6-address | peer-group peer-group-name]
keepalives [in | out]
To disable debugging, use the no debug ip bgp [ip-address | peer-group
peer-group-name] keepalives [in | out] command.
Parameters
ipv6-address (OPTIONAL) Enter the IPv6 address in the x:x:x:x::x format
followed by the prefix length in the /x format. The range
is /0 to /128.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
peer-group peer-
group-name
(OPTIONAL) Enter the keywords peer-group followed by
the name of the peer group.
in (OPTIONAL) Enter the keyword in to view only information
on inbound keepalive routes.
out (OPTIONAL) Enter the keyword out to view only
information on outbound keepalive routes.
Command Modes EXEC Privilege
Command History
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.2.1.0 Introduced on the E-Series ExaScale.
7.4.1.0 Introduced
Usage Information Enter the no debug ip bgp command to remove all configured debug
commands for BGP.
debug ip bgp ipv6 dampening
View information on IPv6 routes being dampened.
C9000 Series
Syntax
debug ip bgp ipv6 unicast dampening [in | out]
To disable debugging, use the no debug ip bgp ipv6 unicast dampening
command.
554
Border Gateway Protocol