Reference Guide

Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information At least one interface must be in Layer 3 mode for the router bgp command to
be accepted. If no interfaces are enabled for Layer 3, an error message appears:
% Error: No router id
configured
Example
Dell(conf)# router bgp 3
Dell(conf-router_bgp)#
set extcommunity bandwidth
Set extended community bandwidth for handling inbound and outbound policies.
Syntax
set extcommunity bandwidth
To disable extended community bandwidth, enter the no set extcommunity
bandwidth command.
Parameters
bandwidth Enter the keyword bandwidth to enable extended
community bandwidth. The range is from 0 to 102400.
Defaults N/A
Command Modes ROUTER MAP
Command History
Version Description
9.9(0.0) Introduced on the C9010.
9.8(0.0) Introduced on the S3048–ON and S4048–ON.
9.7(0.0) Introduced on the S-Series.
Usage Information
A new policy command is introduced in order to attach the Link Bandwidth
extended community only to the prefixes that are received from a neighbor that
satisfy the desired conditions. This command is relevant for both inbound as well
as outbound policy handling (for received prefixes). Also, there is no change to the
set of supported conditions or filters.
470
Border Gateway Protocol