Reference Guide
• For a PE Gigabit Ethernet interface, enter the keyword
peGigE then the pe-id/stack-unit/ port-id information.
in Display information of L2 ingress access-list configured to
an interface.
out Display information of L2 egress access-list configured to
an interface.
Command Modes EXEC
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.4.1.0 Introduced.
Usage information
This command displays ingress or egress L2 access-list information based on a
given option.
If no ingress or egress access-list is attached to an interface, no information
displays and you return to the DELL# prompt.
Example
Dell#show mac access-lists in
Standard mac access list m1
seq 5 permit 11:22:33:44:55:66 count (0 packets)
Standard mac access list m2
seq 5 deny any order 2
seq 10 permit 00:33:00:11:00:77 33:44:55:66:77:88 count (0
packets)
Extended mac access list m3
seq 5 permit host 11:11:11:11:11:11 host 22:22:22:22:22:22
snap eq 600
Dell#
Dell#show mac access-lists out
Standard mac access list m1
seq 5 permit 11:22:33:44:55:66 count (0 packets)
Standard mac access list m2
seq 5 deny any order 2
310
Access Control Lists (ACL)