Reference Guide

ipv6 route-import
Import IPv6 routes leaked by another VRF using the tag specified by that VRF during export of these
routes.
C9000 Series
Syntax
ipv6 route-import tag [route-map-name]
Parameters
route-import Enter the keyword route-import to import IPv6 routes into
the VRF.
tag Enter a tag (ASN number) to specify an import route target
for importing routes from another VRF. To import leaked
routes from another VRF, you must use the same ASN
number that is specified as the export route target at the
source VRF.
route-map-name Enter the name of the route-map to filter the imported
routes.
NOTE: You must use the route-map attribute while
importing routes from the global RTM. Route-maps
enable you to filter routes at the import end based on
the matching criteria that you define in the route-map.
Command Modes
VRF MODE
CONFIGURATION
Command History
Version Description
9.9(0.0) Introduced on the C9010.
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, S6000–
ON, and Z9500.
Usage Information It is possible to configure multiple import conditions per VRF depending on the
exporting VRF.
The export-target and import-target support only the match protocol and match
prefix-list options. Other options that are configured in the route-maps are
ignored.
Related
Commands
ipv6 route-export – exports IPv6 routes to another VRF.
2104
Virtual Routing and Forwarding (VRF)