Reference Guide

Example
Dell#show boot bmp
Reload type is set to normal mode. BMP process is in disabled
state
show boot system
Display information about boot images currently stored on the system.
C9000 Series
Syntax
show boot system all
From a PE console, use the following:
show boot system {stack-unit unit number | all}
Parameters
all Display the boot images stored on the system for the
Control Processor, Route Processor, and line card CPUs.
From a PE console, display boot image information on all
the unit.
stack-unit unit-
number
Display the boot image information for a specified stack-
unit. The stack-unit number range is from 0 to 7.
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010 and C1048P.
9.2(1.0) Introduced on the Z9500.
Example
Dell#show boot system all
Current system image information in the system:
===============================================
Type Boot Type A B
------------------------------------------------------
rpm 0 (CP) DOWNLOAD BOOT 1-0(0-4074) 1-0(0-4081)
rpm 1 (CP) DOWNLOAD BOOT 1-0(0-4074) 1-0(0-4081)
File Management
203