Reference Guide

snmp-server packetsize
Set the largest SNMP packet size permitted. Wen the SNMP server is receiving a request or generating a
reply, use the snmp-server packetsize global configuration command.
C9000 Series
Syntax
snmp-server packetsize byte-count
Parameters
byte-count Enter one of the following values 8, 16, 24 or 32. Packet
sizes are 8000 bytes, 16000 bytes, 32000 bytes, and 64000
bytes.
Defaults 8
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
snmp-server trap-source
Configure a specific interface as the source for SNMP traffic.
C9000 Series
Syntax
snmp-server trap-source interface
To disable sending traps out a specific interface, use the no snmp trap-source
command.
Parameters
interface Enter the following keywords and slot/port or number
information:
• For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
Simple Network Management Protocol (SNMP) and Syslog
1927