Reference Guide

4
File Management
This chapter contains command line interface (CLI) commands needed to manage the configuration files
as well as other file management commands.
The commands in this chapter are supported by the Dell Networking OS on the C9000 switch.
boot system
Specify the location where the Dell Networking OS image used to boot the system is stored.
C9000 Series
Syntax
boot system [gateway ip address | [rpm0 {default | primary |
secondary [ftp: | system:{A:| B:} | tftp:] }] [rpm1 {default |
primary | secondary [ftp: |system:{A:|B:} | tftp:]}]
Parameters
gateway Enter the IP address of the default next-hop gateway for the
management subnet.
ip-address Enter an IP address in dotted decimal format.
rpm0 Enter the keyword rpm0 to specify the route processor
module 0.
rpm1 Enter the keyword rpm1 to specify the route processor
module 1.
default Enter the keyword default to use the default Dell
Networking OS image.
primary Enter the keyword primary to use the primary Dell
Networking OS image.
secondary Enter the keyword secondary to use the secondary Dell
Networking OS image.
ftp: Enter the keyword FTP: to retrieve the image from an FTP
server: ftp://userid:password @host-ip/filepath.
system A: | B: Enter A: or B: to boot one of the flash system partitions.
tftp: Enter the keyword TFTP: to retrieve the image from a TFTP
server: tftp://host-ip/filepath.
186
File Management