Reference Guide

RADIUS Commands
The following RADIUS commands are supported by Dell Networking OS.
debug radius
View RADIUS transactions to assist with troubleshooting.
C9000 Series
Syntax
debug radius
To disable debugging of RADIUS, use the no debug radius command.
Defaults Disabled.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.0 Introduced on the E-Series.
ip radius source-interface
Specify an interface’s IP address as the source IP address for RADIUS connections.
C9000 Series
Syntax
ip radius source-interface interface
To delete a source interface, use the no ip radius source-interface
command.
Parameters
interface Enter the following keywords and slot/port or number
information:
Security
1831