Reference Guide

util-threshold cpu
Configure the high or low CPU utilization thresholds for SNMP traps.
C9000 Series
Syntax
util—threshold cpu {5sec | 1min | 5min} {all | cp |lp slot–id |
pe | rp} {high {0-100} | low {0-100}}
Parameters
cpu-utilization-
time
Enter one of the following values to configure the threshold
level for the time in which a switch CPU can be used:
• 5 sec
• 1 min
• 5 min
cp Enter the keyword cp to configure the CPU utilization time
for the Control Processor CPU.
rp Enter the keyword rp to configure the CPU utilization time
for the Route Processor CPU.
lp slot-id Enter the keyword lp and the linecard processor (lp) slot-id
for which you want to configure the CPU utilization time.
The range for lp slot-id is from 0 to 11.
pe Enter the keywordpe to configure the CPU utilization time
for port extenders (PE) configured in the system. Range is
from 0 to 255.
NOTE: The pe option is only available when the
extended bridge feature is enabled.
all Enter the keyword all to configure the CPU utilization time
on all switch CPUs: Control Processor, Route Processor,
port extender (PE) and line cards.
{{high | low} cpu-
utilization-
threshold-
percentage}
Enter a percentage value to configure the high or low
threshold level for the time in which a switch CPU can be
used. The percentage of CPU use ranges from 0 to 100.
NOTE: A threshold level of 0 disables Syslog and SNMP
traps.
Defaults
• High CPU utilization threshold: 1 min = 85%, 5 min = 80%
• Low CPU utilization threshold: 1 min = 75%, 5 min = 70%
Command Modes CONFIGURATION
180
Control and Monitoring