Reference Guide

Parameters
ip-address Specify an IP network address in dotted decimal format. You
cannot specify a subnet.
Defaults No RIP network is configured.
Command Modes ROUTER RIP
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Usage Information
You can enable an unlimited number of RIP networks.
RIP operates over interfaces configured with any address the network command
specifies.
offset-list
Specify a number to add to the incoming or outgoing route metrics learned using RIP.
C9000 Series
Syntax
offset-list prefix-list-name {in | out} offset [interface]
To delete an offset list, use the no offset-list prefix-list-name {in |
out} offset [interface] command.
Parameters
prefix-list-name Enter the name of an established Prefix list to determine
which incoming routes are modified.
Routing Information Protocol (RIP)
1781