Reference Guide

Version Description
8.3.7.0 Introduced on the S4810.
6.1.1.1 Introduced on the E-Series
Usage Information Use the default pre-defined profiles or configure your own profile. You cannot
delete the pre-defined profiles or their default values. This command enables
WRED configuration mode —(conf-wred).
Related
Commands
threshold — specifies the minimum and maximum threshold values of the WRED
profile.
show hardware
This command displays hardware buffer configurations and counters.
C9000 Series
Syntax
show hardware {linecard number | pe-unit number stack-unit
number} buffer unit number port number buffer-info
Parameters
linecard Line card 0 – 11.
pe-unit PE-unit is use to specify the PE. PE ID 1 – 255.
stack-unit Stack-unit is used to specify the statck unite in the stacked
PE system. Stack-unit within a PE ID 0 – 7.
buffer-unit Buffer unit is used to specify the port-pipe. Buffer-unit 0 –
0.
Defaults None
Command Modes Exec
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
1730
Quality of Service (QoS)