Reference Guide

power inline
Enable inline power and configure maximum power allocation with priority for the powered device
connected to an interface.
C9000 Series
Syntax
power inline {[max_milliwatts ]| priority {critical | high |
low}}
To disable a device that has been enabled for PoE power supply, use the no
power inline command.
Parameters
max_milliwatts (OPTIONAL) Specify the maximum amount of inline power
allocation to a powered device connected to the interface.
Range is 440–30000 milliwatts (mWs). The default value is
30000 mWs.
NOTE: The max_milliwatt configuration is effective only
in Static mode.
priority Enter the keyword priority to specify the PoE priority for
the powered device connected to the interface. Default
priority value is low.
critical Enter the keyword critical to set the PoE priority level as
critical.
high Enter the keyword high to set the PoE priority level as high.
low Enter the keywordlow to set the PoE priority as low.
Defaults Default priority is low.
Command Modes INTERFACE CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
Usage information
The power inline [max_milliwatts} command enables inline power supply
to an interface. You can specify the maximum amount of power allocation to a
device in max-milliwatts, within a range of 440–30000 mW. If a specific power
supply value is not configured, the default value of 30,000 mW is configured as the
maximum power for allocation to powered devices. You can disable the inline
power supply to a port using the no power inline command.
Port Extenders (PE)
1647