Reference Guide

location-led
Toggle the location LED of a specified interface, linecard or port extender (PE) on or off.
C9000 Series
Syntax
location—led {interface interface | linecard slot-id | pe pe-id
stack-unit unit-number | rpm slot-id }{off|on}
Parameters
interface interface Enter the following keywords and slot/port or number
information:
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a Gigabit Ethernet interface, enter the keyword
gigabitethernet then the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
linecard slot-id Enter the keyword linecard and the slot ID. The linecard
slot-id range is from 0 to 9.
pe pe-id Enter the keyword pe and the PE ID. The range is from 0 to
255.
stack-unit unit
number
Enter the keyword stack-unit and the stack unit number.
The range is from 0 to 7.
rpm slot-id Enter the keyword rpm and specify the route processor slot
ID. RPM slot-id values are rpm0 and rpm1 .
on |off Turn the location LED(s) of the specified interfaces, linecard,
port extenders (PE), ports and RPMs on or off.
Default
None
Command Modes
EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
Usage Information
When the location LED setting is turned “on” for a port extender (PE), the main
power supply LED on the PE flashes green light and when the location LED setting
is turned ”off”, the main power supply LED is in a solid green state.
Port Extenders (PE)
1617