Reference Guide

Field Description
Num Ports Displays the number of active ports.
Up Time Displays the number of hours and minutes since the RPM’s
last reboot.
Last Restart States the reason for the last RPM reboot.
Dell Networking
OS Version
Displays the operating software version.
Jumbo Capable Displays a Yes or No indicating if the RPM is capable of
sending and receiving Jumbo frames.
This field does not indicate if the chassis is in Jumbo mode;
for that determination, use the show chassis brief
command.
CP Boot Flash Displays the two possible Boot Flash versions for the control
processor. The [Booted] keyword next to the version states
which version was used at system boot.
RP Boot Flash Displays the Boot Flash version for the Routing Processor.
The [Booted] keyword next to the version states which
version was used at system boot.
CP Mem Size Displays the memory of the control processor.
RP Mem Size Displays the memory of the Routing Processor.
Temperature Displays the temperature of the RPM. Minor alarm status if
the temperature is over 65°C.
Power Status Lists the status of the power modules in the chassis.
Voltage Displays the power rails for the line card.
Part Num Displays the line card part number.
Vendor ID Displays an internal code, which specifies the manufacturing
vendor.
Date Code Displays the line card’s manufacturing date.
Country Code Displays the country of origin. 01 = USA.
Example
Dell#show rpm 0
-- RPM card 0 --
Status : active
Next Boot : online
Card Type : RPM - Route Processor Module (C9000-RPM-2.56T)
Hardware Rev : 4.0
Num Ports : 1
Up Time : 21 min, 28 sec
Last Restart : normal power-cycle
Dell Networking OS Version : 9.9(0.0)
Jumbo Capable : yes
CP Boot Flash : 3.3.1.16 [booted]
150
Control and Monitoring