Reference Guide

match ra
Enable verifying either of the configured source IPv6 address or prefix address or the source MAC address
in the inspected messages. If this command is not configured, the verification process is bypassed.
C9000 Series
Syntax
match ra {ipv6-access-list name | ipv6-prefix-list name | mac-
access-list name}
To reset the access list, use the no match ra{ipv6-access-list | ipv6-
prefix-list | mac-access-list}command.
Parameters
ipv6–access-list
name
Enter the keywords ipv6–access-list then the access-
list name. The access-list name allows a maximum of 140
characters.
ipv6–prefix-list
name
Enter the keywords ipv6–prefix-list then the prefix-list
name. The prefix-list name allows a maximum of 140
characters.
mac-access-list
name
Enter the keywords mac-access-list then the mac-
access-list name. The mac-access-list name allows a
maximum of 140 characters.
Defaults none
Command Modes POLICY LIST CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Inroduced on the C9010.
9.7(0.0) Introduced on the S6000-ON.
9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, and
Z9000 switches.
Related
Commands
• ipv6 nd ra-guard enable — Allows you to configure the RA guard related
commands.
• ipv6 nd raguard policy policy-name — Defines the RA guard policy name and
enter the RA guard policy configuration mode.
1356
Neighbor Discovery Protocol (NDP)