Reference Guide

Version Description
8.3.7.0 Introduced on the S4810.
7.7.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
management-interface
Enable and configure LLDP protocol parameters on the management interface.
C9000 Series
Syntax
management-interface
To remove LLDP configuration on a management interface, use the no
management-interface command.
Command Modes LLDP (conf-lldp)
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
9.2(0.0) Introduced on the Z9000 and S4810.
Usage Information
To enable LLDP on the management interface, use the no disable command in
LLDP-MANAGEMENT-INTERFACE mode (conf-lldp-mgmtIf).
mode
To receive or transmit, set LLDP.
C9000 Series
Syntax
mode {tx | rx}
To return to the default, use the no mode {tx | rx} command.
Parameters
tx Enter the keyword tx to set the mode to transmit.
rx Enter the keyword rx to set the mode to receive.
Link Layer Discovery Protocol (LLDP)
1279