Reference Guide

Usage Information
The advertise dot3–tlv power—via—mdi command enables the system to
advertise IEEE 802.3at power-via-mdi TLV to advertise its power negotiation
capabilities with the powered devices via Link Layer Discovery Protocol (LLDP). You
can configure this command either on a specific interface or globally.
Example
Dell(conf)#interface peGigE 0/0/0
Dell(conf-if-pegi-0/0/0)#protocol lldp
Dell(conf-if-pegi-0/0/0-lldp)#advertise dot3-tlv power-via-mdi
Dell(conf-if-pegi-0/0/0-lldp)#
advertise management-tlv
Advertise management TLVs (Type, Length, Value).
C9000 Series
Syntax
advertise management-tlv {management-address | system-
capabilities | system-description | system-name}
To remove advertised management TLVs, use the no advertise management-
tlv {management-address | system-capabilities | system-
description | system-name} command.
Parameters
management-
address
Enter the keyword management-address to advertise the
management IP address TLVs to the LLDP peer.
system-
capabilities
Enter the keywords system-capabilities to advertise
the system capabilities TLVs to the LLDP peer.
system-
description
Enter the keywords system-description to advertise the
system description TLVs to the LLDP peer.
system-name Enter the keywords system-name to advertise the system
name TLVs to the LLDP peer.
Defaults none
Command Modes CONFIGURATION (conf-lldp)
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
9.1.(0.0) Modified to support management-address parameter.
8.3.19.0 Introduced on the S4820T.
1272
Link Layer Discovery Protocol (LLDP)