Reference Guide

Version Description
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Related
Commands
show lacp — displays the LACP configuration.
debug lacp
Debug LACP (configuration, events, and so on).
C9000 Series
Syntax
debug lacp {config | events | pdu [interface-type [in | out]]}
To disable LACP debugging, use the no debug {config | events | pdu
[interface-type [in | out]]} command.
Parameters
config (OPTIONAL) Enter the keyword config to debug the LACP
configuration.
events (OPTIONAL) Enter the keyword events to debug the LACP
event information.
pdu (OPTIONAL) Enter the keyword pdu to debug the LACP
Protocol Data Unit information.
interface-type in |
out
(OPTIONAL) Enter the following keywords and slot/port or
number information:
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
• For a Ten-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a port extender Gigabit Ethernet interface, enter the
keyword peGigE then the pe-id / stack-unit / port-id
information. The pe-id range is from 0 to 255; the stack-
unit unit-number range is from 0 to 7; and the port-id
range is from 1 to 48.
Optionally, enter an in or out parameter:
• Receive enter in
• Transmit enter out
Link Aggregation Control Protocol (LACP)
1261