Reference Guide

26
IPv6 Access Control Lists (IPv6 ACLs)
IPv6 ACLs and IPv6 Route Map commands are supported on Dell Networking operating system.
NOTE: For IPv4 ACL commands, refer to the Access Control Lists (ACL) chapter.
Important Points to Remember
• Certain platforms require manual CAM usage space allotment. For more information, see the cam-acl
command.
• Egress IPv6 ACL and IPv6 ACL on the Loopback interface is not supported.
• Reference to an empty ACL permits any traffic.
• ACLs are not applied to self-originated traffic (for example, Control Protocol traffic not affected by
IPv6 ACL because the routed bit is not set for Control Protocol traffic and for egress ACLs the routed
bit must be set).
• You can use the same access list name for both IPv4 and IPv6 ACLs.
• You can apply both IPv4 and IPv6 ACLs on an interface at the same time.
• You can apply IPv6 ACLs on physical interfaces and a logical interfaces (Port-channel/VLAN).
• Non-contiguous masks are not supported in source or destination addresses in IPv6 ACL entries.
• Because the prefix mask is specified in /x format in IPv6 ACLs, inverse mask is not supported.
cam-acl
Allocate content addressable memory (CAM) for IPv4 and IPv6 ACLs.
C9000 Series
Syntax cam-acl {default | l2acl number{ ipv4acl number ipv6acl number ipv4qos number
l2qos number l2pt number ipmacacl number vman-qos | vman-dual-qos number
ecfmacl number [ openflow number fcoeacl number | fedgovacl number|
nlbclusteracl number | ipv4pbr number | iscsioptaclnumber | openflow number |
vrfv4ac numberl ]}}
Parameters
default Use the default CAM profile settings and set the CAM as
follows:
• L3 ACL (ipv4acl): 4
IPv6 Access Control Lists (IPv6 ACLs)
1159