Reference Guide

IPv4 Routing

The basic IPv4 commands are supported by Dell Networking operating system on the switch.

arp

To associate an IP address with a MAC address in the switch, use address resolution protocol (ARP).

C9000 Series

Syntax

arp ip-address mac-address interface

To remove an ARP address, use the no arp ip-address command.

Parameters

ip-address Enter an IP address in dotted decimal format.

mac-address Enter a MAC address in nnnn.nnnn.nnnn format.

interface (OPTIONAL) Enter any of the following keywords and slot/

port or number information:

• For the Management interface, enter the keyword

ManagementEthernet then the slot/port information.

The slot range is from 0 to 1 and the port range is 0.

• For a Port Channel interface, enter the keywords port-

channel

then a number. The range is from 1 to 128.

• For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

• For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE then the slot/port information.

• For a port extender (PE) Gigabit Ethernet interface, enter

the keyword peGigE then the pe-id, stack-unitunit

number, and port-ID. The pe-id range is 0–255; the

stack-unit unit number range is 0–7; and the port-id

range is 0–48.

Defaults Not configured.

Command Modes CONFIGURATION

Command History

This guide is platform-specific. For command information about other platforms,

see the relevant Dell Networking OS Command Line Reference Guide.

IPv4 Routing

1091