Users Guide

Configuring C9010 Components to Boot from the RPM CP
Image
By reconfiguring boot variables and resetting a component, you should be able to resolve most issues resulting from
mismatched system images.
To display the boot variables for a C9010 component that you need to configure so that a component boots with the RPM CP
image, enter the show bootvar command at the BOOT_USER# prompt.
The following examples display boot variables and C9010 internal IP addresses for the RPM0 route processor, RPM0 line-card
processor, and line card installed in slot 3.
BOOT_USER# show bootvar
RPM (RP0)
***** Welcome to Dell Networking OS Boot Interface *****
PRIMARY OPERATING SYSTEM BOOT PARAMETERS:
========================================
boot device : ftp
file name : force10/rd/tgtimg/runtime/RP.bin
Management Etherenet IP address : 127.10.10.11
Mask : 255.240.0.0
Server IP address : 127.10.10.10
Default Gateway IP address : 127.10.10.10
username : f10agent
password : imagereq
BOOT_USER# show bootvar
RPM (LP10)
***** Welcome to Dell Networking OS Boot Interface *****
PRIMARY OPERATING SYSTEM BOOT PARAMETERS:
========================================
boot device : ftp
file name : force10/rd/tgtimg/runtime/LP.bin
Management Etherenet IP address : 127.10.10.113
Mask : 255.240.0.0
Server IP address : 127.10.10.10
Default Gateway IP address : 127.10.10.10
username : f10agent
password : imagereq
BOOT_USER# show bootvar
Linecard 3
***** Welcomshow bootvartworking OS Boot Interface *****
Use "help" or "?" for more information.
PRIMARY OPERATING SYSTEM BOOT PARAMETERS:
========================================
boot device : ftp
file name : force10/rd/tgtimg/runtime/LP.bin
Management Etherenet IP address : 127.10.10.43
Mask : 255.240.0.0
Server IP address : 127.10.10.10
Default Gateway IP address : 127.10.10.10
username : f10agent
password : imagereq
Switch Management 81